1.Product name: DIN-rail 1 fiber 4 copper PoE unmanaged industrial switch

2.Product model: X6114P

3.Product specification

Technology standard：IEEE802.3、IEEE802.3u、IEEE802.3ab、IEEE 802.3z、IEEE 802.3x、IEEE802.3af、IEEE802.3at、IEEE802.1q (VLAN Tagging)、IEEE802.1p(QoS)

Function selection of dial switch:

Gigabit switch can select the following working method online:

① standard mode,② cross-device QinQ isolation mode,③ VLAN isolation mode based on downlink port,④ copper forced 10M mode,⑤ cross-device QinQ isolation+copper forced 10M mode, ⑥ downlink based port VLAN isolation+copper forced 10M mode, ⑦ fiber port is high priority+copper port is low priority mode.

Note: Customers can also customize other working modes of the switch according to actual needs.
Product ports：

            Gigabit fiber port: 1*1000Base-X SFP fiber,or

            A module, built-in 1310/1550nm,single mode fiber,20km,LC 1*9 optical module

            B module, built-in 1550/1310nm,single mode fiber,20km,LC 1*9 optical module

            Gigabit copper port：4* 10/100Base-T/1000Base-TX（1 group 1*4 10/1000/1000M RJ45)

            Power supply: DC dual power supply interface(6-pin 5.08mm spacing terminal)

            PoE power supply PIN: 1/2(+),3/6(-),port maximum/average power: 30W/15.4W

            DIP switch interface: select the different working mode of switch network communication online

Transmission distance：twisted pair: 10BASE-T :Cat3,4,5 UTP cable(≤250m)

                                     100/1000BASE-T(X): Cat5 or later UTP cable(≤100m)

                                     Multimode optical module: 1310nm,20/40/60km

                                     Single mode optical module: 1310nm,20/40/60/80/100/120 

Switching properties：

                 Cache: 1.0Mbit

LED Indicators:

                Power indicatior: PWR1,PWR2(Green light)

                Gigabit fiber:1000M(Green light is on)

                Gigabit copper: Link/Act(Yellow light is on) link-down(Yellow light is off)

                Link-up(Yellow light is on and flash,sending and receiving data)

                PoE port(1-4 ports): PD connected and powered normally when green light is on.If connect into external PD,PoE power supply is abnormal when green light is off.

Power supply:

               Access terminal: 6-pin 5.08mm spacing terminal 
               Input voltage: DC48V(46~57)
               Standby power consumption:＜1W;System full-load power consumption:＜65W
               Power supply supports dual power supply redundancy
               Power supply supports non-polarity

Working environment:

               Installation method: DIN-rail or wall-mounted